120 VAC Lamp Dimmer

The full wave phase control circuit below was found in a RCA power circuits book from 1969. The load is placed in series with the AC line and the four diodes provide a full wave rectified voltage to the anode of a SCR. Two small signal transistors are connected in a switch configuration so that when the voltage on the 2.2uF capacitor reaches about 8 volts, the transistors will switch on and discharge the capacitor through the SCR gate causing it to begin conducting. The time delay from the beginning of each half cycle to the point where the SCR switches on is controlled by the 50K resistor which adjusts the time required for the 2uF capacitor to charge to 8 volts. As the resistance is reduced, the time is reduced and the SCR will conduct earlier during each half cycle which applies a greater average voltage across the load. With the resistance set to minimum the SCR will trigger when the voltage rises to about 40 volts or 15 degrees into the cycle. To compensate for component tollerances, the 15K resistor can be adjusted slightly so that the output voltage is near zero when the 50K pot is set to maximum. Increasing the 15K resistor will reduce the setting of the 50K pot for minimum output and visa versa. Be careful not to touch the circuit while it is connected to the AC line.


visit: http://www.discovercircuits.com/list.htm

Transistorized Inverter 60W 12V DC to 230V AC

Download this schematic.




Download datasheet semiconductor component. (PDF Format)

1. BC548
2. BD140
3. 2N6107
4. 2N3055

This is low cost fully transistorised inverter circuit capable of driving medium loads of the order of 40 to 60 watts using battery of 12V, 15 Ah or higher capacity.

Transistors T1 and T2 (BC548) form a 50Hz multivibrator. For obtaining correct frequency, the values of resistors R3 and R4 may have to be changed after testing. The complementary outputs from collectors of transistors T1 and T2 are given to PNP darlington driver stages formed by transistor pairs T3-T4 and T6-T7 (utilising transistors BD140 and 2N6107). The outputs from the drivers are fed to transistors T5 and T8 (2N3055) connected for push-pull operation.

Somewhat higher wattage can be achieved by increasing the drive to 2N3055 transistors (by lowering the value of resistors R7 and R8 while increasing their wattage). Suitable heatsinks may be used for the output stage transistors. Transformer X1 is a 230V primary to 9V-0-9V, 10A secondary used in reverse.

Inverter 100W, 12V DC to 220V AC

Here is 100 Watt Inverter 12V DC to 220V AC schematic diagram.





Download this schematic diagram.




Download datasheet semiconductor component. (PDF Format)

1. CD4047
2. TIP122
3. 2N3055