Nagative voltage generation using 555 timer

This 555 timer based PWM controller features almost 0..100% pulse width regulation using R1, while keeping the oscillator frequency relatively stable. The frequency is dependent on values of R1 and C1, values shown will give a frequency range from about 170 to 200 Hz. Any 555 chip will do, CMOS is fine as well. Diodes are not critical, I used 1N4148. Total cost of parts is about $2. As the whole thing is quite trivial, it’s very easy to build on prototyping board like I did.

Download this schematic diagram.

Download semiconductor datasheet parts. (PDF Format)

1. NE555

2. BD140

PWM Speed Motor Controller By IC 555-Electronic control circuit - [Link]

Electronic Timer Switch.

This electronic timer switch project is a good project to build to simulate the presence of occupants in a house. In these days when security is becoming more of a concern when no one is at home, having this device will deter the thief from breaking in. When power up, after 60 minutes, the relay will turn ON for 100 secs, OFF for the next 100 secs, and ON again for 100 secs before OFF again for the next 60 mins. This sequence will be repeated. A device such as a lamp that is connected to the relay will turn ON and OFF according to this timing.

Schematic Diagram

The schematic of the project is as shown below.

Download this schematic diagram.




Parts List

Download datasheet semiconductor component. (PDF Format)

1. CD4060B
2. IN4148
3. IN4003
4. 2SC2002