5,000W ultra-light, high-power amplifier, without switching-mode power supply

Download this schematic diagram.

download semiconductor component datasheet. (PDF Format)

1. MPSA.42

2. MPSA.92

3. MPSW.42

4. MPSW.92

5. 2SA1302

6. 2SC3281

7. MJL21193

8.MJL21194

9. LM7815

10. LM7915

This circuit is of an 2x 2,500W RMS stereo amplifier, super-light and without switching-mode power supply. The circuit just shows a channel, and the power supply that it assists to the two channels. The audio circuit should be duplicated, but the power supply assists to the two channels without problems.

A special care should be destined to the insulating transformer of the audio line, that should be of audio-high-quality, of the type used in microphone pre amps input line. The whole group (2 channels) of 5,000W RMS it should not weigh more than 32 lbs, already inside of an appropriate metallic box.

WARNING:

This circuit is exclusively for amateur use. It contains not-isolated parts of the electric AC net and it can be very dangerous. The connections for the speakers are not isolated of the domestic AC net and it requests extra care. This procedure seeks to substitute a conventional power supply with great weight and cost reduction, without necessarily to use a switching-mode power supply.

This procedure cannot be allowed in some countries for commercial-use. The author doesn't have any responsibility for the form as that circuit it will be applied.

LM2577 5V to 12V DC Converter step up Voltage Regulator

DC to DC step up voltage regulator. Wide input voltage 3.5Vdc to 40Vdc. This is Circuit DC to DC converter step up vol



Download this schematic.



Download list semiconductor datasheet. (PDF Format)

1. LM2577
2. IN5821

http://www.circuits-lab.com/

Injector Pulse Width Monitor with LM324 ,LM3914

The schematic for the pulse width monitor. The heart of the circuit is the transistor current source which charges cap C10 to form an integrator. The theory is that the cap is charged and the voltage across it increases linearly for the amount of time that the injector is energized. As the injector is switched off the voltage in C10 is stored in cap C9 and then C10 is reset to 0 volts to get ready for the next cycle. The output of the circuit is the voltage across cap C9, this voltage is fed directly into U3 the bar graph chip to be displayed as a value between 1-10 on the LEDs. Potentiometer R31 sets the charge rate on C10 and basically sets the max injector on time that can be displayed.

Download this schematic diagaram.

download datasheet the semiconductor component. (PDF Format)

1. LM324

2. LM3914

3. CD4058

4. LM7805

5. MN3206

6. MN3906

7. 2N2222

8. IN214

9. IN5233

Injector Pulse Width Monitor with LM324 ,LM3914 - [Link]

Temperature Monitor with IC LM741 or LM301

Using a thermistor in the position shown makes a heat activated sensor. A change in temperature will alter the output of the opamp and energize the relay and light the LED. Swapping the position of the thermistor and 47k resistor makes a cold or frost alarm.

Download this schematic.

Download semiconductor parts datasheet. (PDF Format)

1. LM741

2. LM301

3. BC182B

Temperature Monitor with IC LM741 or LM301 - [Link]